Things I designed and built from zero
Every project here started as a problem with no off-the-shelf answer. Open a panel for the full story.
★ Featured
Custom Cement 3D Printer
My major college engineering project: a cement-based 3D printer designed and built from scratch, covering the mechanical structure, motion, electronics and extrusion.
Details
Custom Cement 3D Printer
Problem
Cement behaves nothing like thermoplastic. Material consistency, flow rate, extrusion pressure, nozzle geometry and layer deposition all had to be solved, and motion and material flow had to work as one system.
Process
A BigTreeTech controller with stepper motors and drivers, a custom auger-based extruder and a peristaltic pump for material delivery, running Marlin firmware. Designed in FreeCAD and refined through repeated build, test and fix cycles.
Result
A complete printer, built by hand, where the motion system and the cement flow work together to lay down layers.
- Concept
- Mechanical design
- Electronics
- Fabrication
- Assembly
- Control
- Testing
- Iteration
"I didn't just use a 3D printer. I built one for a material it was never designed to print."
- BigTreeTech
- Marlin
- FreeCAD
- Stepper motors & drivers
- Auger extrusion
- Peristaltic pump
Universal Mouldable Splint
A splint printed flat on a standard printer, then heat-formed with hot water to fit the patient's limb.
Details
Universal Mouldable Splint
Problem
The idea came from a hospital visit. Casts are heavy and bulky, and one-size-fits-all splints rarely fit well.
Process
A flat-bed-printable design that softens in hot water and is shaped directly on the limb.
Result
A splint that is lighter and less bulky than a cast, with adaptable geometry, designed for low-cost local fabrication.
- FDM printing
- Thermoforming
- Product design
A product-development concept, not a clinically validated medical device.
3D-Printed Electric Guitar
Concept & modelling
A Stratocaster-inspired electric guitar, sketched out and fully modelled in Autodesk Fusion, designed to be 3D printed.
Details
3D-Printed Electric Guitar
Concept & modellingProblem
A full guitar body is far bigger than a hobby print bed, and it has to survive string tension.
Process
A 20 × 40 mm aluminium T-slot extrusion runs from the body into the neck as the backbone. The body has hexagonal through-holes and is split into bolt-together modules that fit a 220 × 220 × 250 mm bed.
Result
Still in the concept and physical-modelling phase: everything is sketched out and modelled in Fusion, and the 3D model is ready. Spin it below. No physical build yet.
Loading model…
Tap to rotate
Drag to rotate · scroll or pinch to zoom · double-click to reset
- Autodesk Fusion
- 25.5" scale
- 22 frets
- Two humbuckers
- Fixed bridge
- Volume, tone & 3-way selector
Gesture-Controlled Robotic Arm
Built single-handedly: a laser-cut acrylic robotic arm that follows hand gestures through computer vision.
Details
Gesture-Controlled Robotic Arm
Problem
Control a robotic arm naturally, with your hand, without joysticks or a remote.
Process
The arm is cut from 3 mm acrylic sheet on a laser cutter. MediaPipe tracks 21 points on the hand, YOLOv8 handles detection, and an Arduino drives the motors.
Result
An arm that responds to hand movements in real time.
- MediaPipe
- YOLOv8
- Python
- Arduino
- 21-point hand tracking
- Laser-cut 3 mm acrylic